An amsing post from one of the highest performer Tim Ferris
The PX Project
The PX Project, a single 3-hour cognitive experiment, produced an average increase in reading speed of 386%.
It was tested with speakers of five languages, and even dyslexics were conditioned to read technical material at more than 3,000 words-per-minute (wpm), or 10 pages per minute. One page every 6 seconds. By comparison, the average reading speed in the US is 200-300 wpm (1/2 to 1 page per minute), with the top 1% of the population reading over 400 wpm…
If you understand several basic principles of the human visual system, you can eliminate inefficiencies and increase speed while improving retention.
To perform the exercises in this post and see the results, you will need: a book of 200+ pages that can lay flat when open, a pen, and a timer (a stop watch with alarm or kitchen timer is ideal). You should complete the 20 minutes of exercises in one session.
First, several definitions and distinctions specific to the reading process:
A) Synopsis: You must minimize the number and duration of fixations per line to increase speed.
You do not read in a straight line, but rather in a sequence of saccadic movements (jumps). Each of these saccades ends with a fixation, or a temporary snapshot of the text within you focus area (approx. the size of a quarter at 8? from reading surface). Each fixation will last ¼ to ½ seconds in the untrained subject. To demonstrate this, close one eye, place a fingertip on top of that eyelid, and then slowly scan a straight horizontal line with your other eye-you will feel distinct and separate movements and periods of fixation.
B) Synopsis: You must eliminate regression and back-skipping to increase speed.
The untrained subject engages in regression (conscious rereading) and back-skipping (subconscious rereading via misplacement of fixation) for up to 30% of total reading time.
C) Synopsis: You must use conditioning drills to increase horizontal peripheral vision span and the number of words registered per fixation.
Untrained subjects use central focus but not horizontal peripheral vision span during reading, foregoing up to 50% of their words per fixation (the number of words that can be perceived and “read” in each fixation).
You will 1) learn technique, 2) learn to apply techniques with speed through conditioning, then 3) learn to test yourself with reading for comprehension.
These are separate, and your adaptation to the sequencing depends on keeping them separate. Do not worry about comprehension if you are learning to apply a motor skill with speed, for example. The adaptive sequence is: technique ‘ technique with speed ‘ comprehensive reading testing.
As a general rule, you will need to practice technique at 3x the speed of your ultimate target reading speed. Thus, if you currently read at 300 wpm and your target reading speed is 900 wpm, you will need to practice technique at 1,800 words-per-minute, or 6 pages per minute (10 seconds per page).
We will cover two main techniques in this introduction:
1) Trackers and Pacers (to address A and B above)
2) Perceptual Expansion (to address C)
First – Determining Baseline
To determine your current reading speed, take your practice book (which should lay flat when open on a table) and count the number of words in 5 lines. Divide this number of words by 5, and you have your average number of words-per-line.
Example: 62 words/5 lines = 12.4, which you round to 12 words-per-line
Next, count the number of text lines on 5 pages and divide by 5 to arrive at the average number of lines per page. Multiply this by average number of words-per-line, and you have your average number of words per page.
Example: 154 lines/5 pages = 30.8, rounded to 31 lines per page x 12 words-per-line = 372 words per page
Mark your first line and read with a timer for 1 minute exactly-do not read faster than normal, and read for comprehension. After exactly one minute, multiply the number of lines by your average words-per-line to determine your current words-per-minute (wpm) rate.
Second – Trackers and Pacers
Regression, back-skipping, and the duration of fixations can be minimized by using a tracker and pacer. To illustrate the importance of a tracker-did you use a pen or finger when counting the number of words or lines in above baseline calculations? If you did, it was for the purpose of tracking-using a visual aid to guide fixation efficiency and accuracy. Nowhere is this more relevant than in conditioning reading speed by eliminating such inefficiencies.
For the purposes of this article, we will use a pen. Holding the pen in your dominant hand, you will underline each line (with the cap on), keeping your eye fixation above the tip of the pen. This will not only serve as a tracker, but it will also serve as a pacer for maintaining consistent speed and decreasing fixation duration. You may hold it as you would when writing, but it is recommended that you hold it under your hand, flat against the page.
1) Technique (2 minutes):
Practice using the pen as a tracker and pacer. Underline each line, focusing above the tip of the pen. DO NOT CONCERN YOURSELF WITH COMPREHENSION. Keep each line to a maximum of 1 second, and increase the speed with each subsequent page. Read, but under no circumstances should you take longer than 1 second per line.
2) Speed (3 minutes):
Repeat the technique, keeping each line to no more than ½ second (2 lines for a single “one-one-thousand”). Some will comprehend nothing, which is to be expected. Maintain speed and technique-you are conditioning your perceptual reflexes, and this is a speed exercise designed to facilitate adaptations in your system. Do not decrease speed. ½ second per line for 3 minutes; focus above the pen and concentrate on technique with speed. Focus on the exercise, and do not daydream.
Third – Perceptual Expansion
If you focus on the center of your computer screen (focus relating to the focal area of the fovea in within the eye), you can still perceive and register the sides of the screen. Training peripheral vision to register more effectively can increase reading speed over 300%. Untrained readers use up to ½ of their peripheral field on margins by moving from 1st word to last, spending 25-50% of their time “reading” margins with no content.
To illustrate, let us take the hypothetical one line: “Once upon a time, students enjoyed reading four hours a day.” If you were able to begin your reading at “time” and finish the line at “four”, you would eliminate 6 of 11 words, more than doubling your reading speed. This concept is easy to implement and combine with the tracking and pacing you’ve already practiced.
1) Technique (1 minute):
Use the pen to track and pace at a consistent speed of one line per second. Begin 1 word in from the first word of each line, and end 1 word in from the last word.
DO NOT CONCERN YOURSELF WITH COMPREHENSION. Keep each line to a maximum of 1 second, and increase the speed with each subsequent page. Read, but under no circumstances should you take longer than 1 second per line.
2) Technique (1 minute):
Use the pen to track and pace at a consistent speed of one line per second. Begin 2 words in from the first word of each line, and end 2 words in from the last word.
3) Speed (3 minutes):
Begin at least 3 words in from the first word of each line, and end 3 words in from the last word. Repeat the technique, keeping each line to no more than ½ second (2 lines for a single “one-one-thousand”).
Some will comprehend nothing, which is to be expected. Maintain speed and technique-you are conditioning your perceptual reflexes, and this is a speed exercise designed to facilitate adaptations in your system. Do not decrease speed. ½ second per line for 3 minutes; focus above the pen and concentrate on technique with speed. Focus on the exercise, and do not daydream.
Fourth – Calculate New WPM Reading Speed
Mark your first line and read with a timer for 1 minute exactly- Read at your fastest comprehension rate. Multiply the number of lines by your previously determined average words-per-line to get determine your new words-per-minute (wpm) rate.
Congratulations on completing your cursory overview of some of the techniques that can be used to accelerate human cognition (defined as the processing and use of information).
Final recommendations: If used for study, it is recommended that you not read 3 assignments in the time it would take you to read one, but rather, read the same assignment 3 times for exposure and recall improvement, depending on relevancy to testing.